Programmed 20877116 Fuel System Control Module VIN Flashed GM FSCM

  
Is Your GM Truck or SUV Stalling, Hesitating, or Refusing to Start? If your engine cranks but won't start, stalls unexpectedly, or runs with reduced power, the FSCM is the likely culprit. This critical component regulates the voltage sent to your fuel pump, and when it fails, it can leave you stranded. Stop the guesswork and get the definitive, ready-to-install solution with our Programmed 20877116 Fuel System Control Module. Common Symptoms of a Failing FSCM & Your Solution.

A failing fuel pump driver module can manifest in several ways, often triggering specific Diagnostic Trouble Codes (DTCs). If you're experiencing any of the following, this module is your answer. No-Start Condition: The engine turns over but never fires up due to a lack of fuel pressure.

Engine Stalling: The vehicle may start and run for a short time before stalling, especially under load. Reduced Engine Power: Your vehicle may enter a "limp mode" with severely limited acceleration. Check Engine Light: Common codes include P069E, P0230, P025A, and U0109 (Lost Communication with Fuel Pump Control Module). Our service eliminates the need for an expensive trip to the dealership. We take a genuine GM module and program it with the latest official software updates, specifically matched to your vehicle's VIN.

This ensures perfect communication and restored functionality right out of the box. An Expert's Insight: Why Pre-Programmed is the Only Way to Go.

As a technician, I've seen countless drivers get stuck with a new module that doesn't work because it wasn't programmed. These FSCMs are often mounted on the frame rail, exposed to water, salt, and vibration, which leads to internal failure. Simply swapping the part isn't enough; the module must be coded to the vehicle's BCM and security system. Our pre-programming service handles this complex step for you. It's the smartest, most efficient way to get your vehicle running reliably again. Plug-and-Play Installation: Arrives pre-flashed to your specific VIN. No dealer visit or special tools required for programming. Guaranteed Compatibility: A direct replacement for part numbers 20791901, 20827745, 20877116, and 20850927. Restores Vehicle Performance: Cures no-start, stalling, and low-power conditions by re-establishing precise fuel pump control. Don't let a faulty module keep you off the road.

How do I provide my VIN for programming? We will provide clear instructions on how to do this. Is this part truly plug-and-play? Where is the FSCM located on my vehicle? On most trucks and large SUVs (like the Silverado, Tahoe, and Escalade), it is typically mounted on the driver's side frame rail, near the spare tire.

On other vehicles like the Traverse or Enclave, it's often on the rear crossmember. What happens if I don't provide a VIN? The module will not work. It is essential that we program the part to your vehicle's VIN.

An unprogrammed module will not be recognized by your vehicle's computer system, and it will not start or run. Does this module fix a U0109 code? Yes, a U0109 code indicates Lost Communication With Fuel Pump Control Module.

This is a very common code for a failed FSCM. Replacing your old module with this pre-programmed unit is the correct repair for that fault code. Category: Fuel Pump Control Module (FPCM). To program your module, we require your full 17-digit VIN. Labor costs are not covered.

9131 Highway 71 NE Spicer, MN, 56288.