Programmed 20877116 Fuel System Control Module GM Plug & Drive

  

Is Your GM Vehicle Stalling, Hesitating, or Refusing to Start? A sudden loss of power, erratic engine performance, or a dreaded no-start condition can leave you stranded and frustrated. These are classic signs of a failing Fuel System Control Module (FSCM), a critical component responsible for delivering the precise amount of fuel your engine needs. When it falters, it can trigger diagnostic trouble codes like P069E, P0230, or P0606, and bring your daily routine to a halt.

Don't let a faulty module dictate your schedule-take control with a reliable, pre-programmed solution. Common Symptoms & Your Definitive Solution. If you're experiencing any of the following, a failing FSCM is the likely culprit. Engine cranks but won't start. Poor acceleration and engine hesitation.

Check Engine Light with fuel-related codes e. This is the definitive fix. We offer a genuine GM Programmed 20877116 Fuel System Control Module that arrives at your door ready for installation. We take your vehicle's VIN and flash the module with the very latest, most stable software from GM.

This means it's a true plug-and-drive part, no extra steps required. Restored Engine Performance: Eliminate stalling, hesitation, and hard starts. Regain the smooth, responsive, and reliable power you expect from your vehicle. Direct OEM Replacement: Guarantees a perfect fit and seamless integration with your vehicle's existing systems and wiring harnesses. Enjoy the confidence that comes with a quality part protected against defects.

An Expert's Insight on FSCM Failures. As a technician, I've replaced hundreds of these modules. On many GM trucks and SUVs, the FSCM is mounted to the frame rail, exposed to water, road salt, and debris. This constant environmental assault leads to corrosion on the circuit board and connector pins, causing the exact issues you're facing. Our Programmed 20877116 Fuel System Control Module isn't just a replacement part; it's a streamlined repair process.

How do I provide my VIN for programming? Is any additional programming required after installation? The module arrives 100% ready for installation. Because we program it to your specific VIN, it is a true plug-and-drive solution.

Just install the part, connect the electrical harness, and you're good to go. Will this fix a P069E trouble code?

Yes, a faulty FSCM is the most common cause of a P069E code (Fuel Pump Control Module Requested MIL Illumination). Replacing your old module with this pre-programmed unit is the correct and effective repair for this issue. Is this a genuine GM part? Yes, this is a genuine OEM part, ensuring perfect compatibility and adherence to factory performance standards. We program it using official GM software and calibrations.

Where is this module located on my vehicle? On most trucks and large SUVs (like the Silverado, Tahoe, Escalade), it's on the driver's side frame rail. On other vehicles, it might be in the trunk area or near the rear crossmember. Always consult a repair manual for your specific vehicle to confirm the exact location. Category: Fuel Pump Control Module (FPCM).

To program your module, we require your full 17-digit VIN. Labor costs are not covered. 9131 Highway 71 NE Spicer, MN, 56288.